============================================================== MVR-64 multiverter Release Notes Firmware version: 1.3, 2016-11-18, Document status: 2016-11-18 ============================================================== NOTE: Although the firmware has been extensively tested, there is no guarantee that everything is 100% compatible. If you run into problems, please drop us a note to and we will look into it. Most things can be fixed via a firmware update. GENERAL ------- - Remote control (MIDI, RS485, PC, Network) is not supported. - Varispeed operation is not supported. ADAT ---- - 32kHz/64kHz/128kHz samplerates are not supported. AES50 ----- - 192/176.4kHz samplerates are not implemented. Let us know if you require it! - 32/64/128kHz samplerates are not supported because they are not specified for AES50. - The MADI-TP port can be switched to function as second AES50 port (adapter cable required due to different pinout). It is possible to combine the channels from both AES50 ports into one logical interface. This feature enables full 64ch@48k and is called "channel aggregation". - When the MVR-64 is clock master connected to a Behringer X32: If the X32 was initally set to a different samplerate, the connection is not automatically re-established after the X32 is set to the correct samplerate. To re-establish the connection, either: - temporarily select another clock source or sample frequency on the MVR-64, - disconnect or reconnect the AES50 cable - power cycle the MVR-64. Dante ----- - Make sure to use the latest version of the Dante Virtual Soundcard, especially after upgrading to Windows 10. Older versions are likely to be broken and produce incorrect audio ("digital noise"). - Channels which are subscribed-to-self (looping back Dante inputs to Dante outputs) on the Multiverter are distorted, when clock speed is 96kHz and clock source is set to non-Dante. This affects only channels looped back by the Brooklyn module, not data coming from or going to the network. Wordclock --------- - Input termination is default OFF. To switch termination On 1) Remove power from the device 2) Open the cover (2x Torx T10 screws) and lift it on the side of the screws 3) Locate the red DIP switch at the wordclock jack. Move Switch #1 to "ON" to enable 75 ohms termination. MIDI ---- - Not implemented, function will be supplied later as firmware update. RS485 ----- - Not implemented, function will be supplied later as firmware update. PC (USB) ------- - Only used for firmware update. Remote control over this is not implemented, but will be supplied later as firmware update. Remote control software ----------------------- - Non-existent yet. In the future, there will be an all-in-one PC/Mac cross plattform application for remote control and firmware update management. This will also allow per-channel routing between different interfaces.